Installation Guide
Applies to acoustic wall panels · 240 / 270 / 300 cm
Screw or glue. On the wall in three steps.
The panels are easy to fit yourself: prepare the wall, cut to size if needed and fix. For each panel choose screws through the felt — invisible — or High Tack construction adhesive. A panel is up in a few minutes.
What you need
Prepare the wall
Make sure the wall is clean, dry and clear. Remove nails and hooks and wipe off dust — especially if you are gluing.
Cut to size
Need a shorter panel? Measure, mark a line and cut with a hand saw or circular saw. If the standard length fits, skip this step.
Align the first panel
Hold the first panel level against the wall and mark its position. This panel sets the line for all the others — take your time here.
Fix panel by panel
Fix the panel with screws or adhesive (see below) and slide the next one tightly against it. Work from left to right and check with the level every few panels.
Option AScrews
Drive 8 black screws per panel through the felt into the wall. Because the screws sink into the felt, they are invisible once fitted. Spread them along the length, on both sides.
Handy if you want to move or remove the panels later.
Option BGlue
Apply High Tack adhesive in beads to the back of the panel and press it firmly against the wall. 1 tube glues 2 panels. The adhesive is available at any DIY store.
No screws, no drilling — but you do need a clean, load-bearing surface.